UTC Fire and Security Interlogix NX-535N, Руководство по установке

Страница: 13 / 19

NX-535N Voice Module Installation Manual 11
Event message #5 Idem Event message #1 8.5 sec
Event message #6 Idem Event message #1 8.5 sec
Event message #7 Idem Event message #1 8.5 sec
Event message #8 Idem Event message #1 8.5 sec
Event message #9 Idem Event message #1 8.5 sec
Event message #10 Idem Event message #1 8.5 sec
Event message #11 Idem Event message #1 8.5 sec
Event message #12 Idem Event message #1 8.5 sec
Event message #13 Idem Event message #1 8.5 sec
Event message #14 Idem Event message #1 8.5 sec
Event message #15 Idem Event message #1 8.5 sec
Kiss-off message Played back after sending kiss-off by means of
DTMF code 10 sec
Address message Played back together with event message 20 sec
Programming the control panel
Format (protocol)
The format used for voice reporting with the NX-535N is format 16.
This is programmed in the control panel on location 2 (for phone #1)
Assigning messages to alarm events
Once you have configured the phone and recorded the messages into the NX-
535N, you need to assign each event you want to report to a recorded message.
Each event can have one of the 15 pre-recorded voice messages assigned to it.
The control panel has a communicator code for each event. Having a record of
your voice messages is useful here.
Assigning messages to a zone configuration group
Assigning messages to a zone configuration group will be done in the location for
the “ALARM EVENT CODES FOR THE CONFIGURATION GROUPS”. These
locations start at location 110 (for zone configuration group 1) till location 168 (for
zone configuration group 30). In these locations you just have to fill in a value
between 1 and 15, which means selecting 1 of the 15 messages you have pre-
recorded.