Utah Sandar UTAH-100, Руководство пользователя и инструкция по установке

Страница: 50 / 80

User Manual & Installation Guide
UTAH-100/XHDA Series
Document: SA3228-User-1.1
Date: 2009-10-07, Rev. 1.1
START UP
•
Connect power to the unit
•
The device is configured with a static IP address for network connectivity
•
Connect the (not supplied) crossed cable between the device and a PC to change the network
configuration to suit your LAN. The default IP address is 192.168.125.123.
•
For configuration and monitoring, open the web browser and go to the address
http://[IP address].
•
For protected sites, use login name “admin” and the default password “password”
Web interface
Figure 1 shows the front page of the web interface. Temperature and voltages from two sensor
devices are monitored at the top. In the “Misc” box the connection status is either connected or
disconnected which tells whether the web browser has contact to the device or not. From the drop-
down box the frequency at which the status is updated can be selected (default every 5 seconds).
The image in the middle represents the front side of the UTAH-100/XHDA. In addition to the LEDs
which turn on if a signal is present, the signal type is also written below. If the mouse pointer is
moved over each of the channel names on the front panel, the box at the bottom is showing. This
box shows the signal path and the signal types detected by the different internal reclockers. Also an
image of the back side is provided to display the actual BNCs that are in use for the current channel.
Figure 1
8