Utah Medical Products FINESSE +, Руководство по обслуживанию

Страница: 15 / 54

Service Manual
11
Installation
Initial Setup
1. Unpack the system. Retain the packing material and box for future use.
2. Inspect the system for any visible damage or missing accessories. If damage is found, contact
Utah Medical Products for assistance.
3. Place on a flat, level surface at working height within six feet of the operating area.
CAUTION: Do not choose a location where the system will be adjacent
to or stacked with other electromedical equipment. If operating the
system in close proximity to other equipment, observe the functioning of the
and other equipment to verify normal operation in the configurations that
they will be used.
4. Connect the footswitch (if used).
5.
Install the Internal Filter (item number SSE-500), if not already done
. Remove
the internal filter retaining ring from the front of the system by rotating it to the
"unlocked" position, then pull outward. Place the internal filter inside the smoke
evacuator port until it is nearly flush against the front panel. Replace the internal filter
retaining ring, lining up the position pointer on the ring with the "unlocked" icon, inserting
the ring until it is flush against the front panel, and rotating until the position pointer is
aligned with the "locked" icon.
Do not operate the system without the internal
filter installed.
6
. Plug the system into any standard power outlet, corresponding to the voltage range
indicated on the system rear panel.
CAUTION: To avoid the risk of electric shock, the system must only
be connected to a supply mains with protective earth (ground). To avoid
damage to the power cord and receptacle, and if used, the footswitch cord and
receptacle, keep the rear of the system at least 3 inches (8cm) from all
obstacles.
Functional Checks
1. Install handswitch pencil into the three-point connector on front panel.
2. Toggle the main power switch to the "on" position. Five things should happen:
• the green lamp in the power switch should light,
• the cut and coag output settings should display the current setting,
• the standard dispersive pad icon, located above the pad connector, will illuminate,
• the orange pad connection error indicator will light, and
• an interrupted error tone should sound.