16
System Start-up Instructions
1. Once all the plumbing has been connected, open the main water shutoff valve.
2. Plug the Aquatrol valve into an approved power source that is constantly energized.
3. Once the valve has settled on the time of day, start an Immediate Manual Regeneration
(See page 8). The valve will immediately start moving to the BACKWASH position.
4. Open the inlet on the bypass valve slowly and allow water to enter the unit. Allow all air to
escape from the unit before turning the water on fully then allow water to run to drain for
the entire backwash cycle or until all media fines are washed out of the filter indicated by
clear water coming from the drain hose.
5. The valve will automatically advance to the RINSE position. Check the drain line flow.
Allow the water to run for the entire RINSE cycle until the water is clear.
6. The valve will automatically advance to the SERVICE position after the RINSE cycle is
complete. Open the outlet valve on the control valve bypass, then open the nearest treat-
ed water faucet and allow the water to run until clear, close the tap and replace the faucet
screen.
7. Installation is complete.
Installation, Operation and Maintenance Manual
AQF-CX-100 & AQF-CX-200
