US Water Systems Aquapurion 200-APRO Series, Руководство пользователя

Страница: 6 / 24

Installation Instructions
Residential Reverse Osmosis Drinking Water System
Page 6
B. Mounting the faucet
1. Install the faucet as shown in Fig. 1 on the previous page.
Assistance may be needed to hold the faucet in place
while the nut is tightened.
2. Once the faucet is secure, install the 7/16” UNS x 3/8” QC
faucet connector on the threaded nipple. This fitting
doesn’t require sealant. This fitting will seal at the beveled
surface. Tighten the fitting hand tight then an additional ½
turn with a wrench or pliers.
3. Now push the blue tube into the faucet connector. Leave
the other end of the blue tube unconnected for now, it will
be connected later in the installation.
4. If an air gap faucet is being used continue to the next
steps. Push the 1/4” drain line from the RO module on to
the smaller brass barb on the bottom of the faucet. Be
sure the tube is completely pushed on the barb or a leak
could occur.
5. Now push the supplied piece of 3/8” black tubing on the
larger brass barb on the bottom of the faucet. Be sure the
tube is completely pushed on the barb or a leak could
occur.