US Water Systems Aquapurion 200-APRO Series, Руководство пользователя

Страница: 13 / 24

Installation Instructions
Residential Reverse Osmosis Drinking Water System
Page 13
5. Lubricate the O-ring on the membrane housing and install
the cap hand tight. Tighten the cap an additional 1/8 - 1/4
turn.
6. Push the 1/4” tubing back into the elbow fitting.
BE SURE
it is fully seated in the fitting or a leak could occur.
H. RO unit installation
The RO unit is normally mounted to the sink cabinet sidewall,
depending on where supply tank is to be located. Generally
the unit is installed at the front of the cabinet and the tank at
the rear.
To mount the unit, elevate it at least 2” off the floor, level it and
mark the location of mounting holes needed. Drill holes for
mounting screws and install screws, allowing the mounting
bracket slots to slip over them.
NOTE: If the cabinet sidewalls are not solid, unit may sit
on the floor with screws to keep it against the cabinet in a
vertical position. The system doesn’t have to be secured
to the wall but it is a good practice. If the system is not
mounted to the cabinet wall and the tubing is not cut
short, the module and be removed from the cabinet
during filter changes.
I. Final tubing connections
With all components in place, complete final tubing
connections using these guidelines:

Tubing should follow contour of the cabinets.

Cut tubing to desired length using square cuts or a proper
cutting devise.

Make no sharp bends
Under sink installations following installation diagram and the
following procedures:
1. Connect the blue tubing from faucet to RO unit at the post
carbon filter outlet fitting.