US Robotics 5633B, Руководство по установке

Страница: 5 / 100

W
INDOWS
98SE/M
E
/2000/XP O
PERATING
S
YSTEM
I
NSTALLATION
3
NOTE: If you are a Windows 98 First Edition user, you will not be able to use this device. If
you are not sure if you are using Windows 98 First Edition, right-click My Computer and
Properties . If your version is Windows 98, version 4.10.1998 , you are using Windows 98
First Edition.
Minimum System Requirements:
98SE, and Me: Pentium II, 300 Mhz, 128 MB RAM
2000 and XP: Pentium III, 500 Mhz, 128 MB RAM
Step 1: Prepare for installation.
NOTE: Before you begin, we recommend you uninstall any other modems you have in your
system. Refer to your previous modem’s documentation for instructions.
Write your new U.S. Robotics modem’s serial number in the box below. The serial number
is located on the white bar code sticker on the bottom of the modem and on the modem’s
box. If you ever need to call our Technical Support department, you will need this number
to receive assistance.
Step 2: Connect the modem to the computer.
Connect the USB A to B cable to the modem and the computer. When looking for the USB
port on the back of your computer, look for ports labelled USB or with the icon .
Plug the rectangle connector end of the cable into the computer’s USB port; plug the
square connector end into the USB port on the 56K Faxmodem USB.
NOTE: The power light (PWR LED) does not illuminate until the drivers are installed in
Step 4.
Step 3: Connect the modem to an analogue phone line.
Plug one end of the provided phone cord into the jack on the modem labelled TELCO and
plug the other end into an analogue phone wall jack.
WARNING: The phone socket you use must be for an ANALOGUE phone line. Most office
phones are wired through DIGITAL lines. Be sure you know what type of line you have. The
modem may be damaged if you use a digital phone line.
Step 4: Install the modem.
The operating system should report Found New Hardware and start the Add New
Hardware Wizard. When the “Add New Hardware Wizard”
screen appears, click Next then
insert the Installation CD in the CD-ROM drive.
Windows 98SE
Select Search for the best driver for your device (Recommended) and click Next.
Click Specify a location and type D:\ . Click Next . (If your CD-ROM uses a different
letter, type that letter in place of "D".) When Windows locates the correct drivers for
the U.S. Robotics USB Modem Enumerator, click
Next . When Windows is finished
installing the software, click Finish . The wizard will then detect and report a search
for drivers for the Modem Device; click Next . Choose Search for the best driver for
your device (Recommended) and click Next . Click Specify a location and type D:\ .