Urrea HG909, Руководство пользователя и гарантия

Страница: 22 / 32

22
• Uncoil high pressure hose completely before
using pressure washer.
• Connect garden hose to water inlet on pres-
sure washer pump.
• Turn ON water, point gun in a safe direction
and squeeze trigger to purge pump system of
air and impurities.
NOTE: DO NOT run the pump without the wa-
ter supply connected and turned on. Damage
to equipment resulting from failure to follow
this instruction will void warranty.
• Attach wand to spray gun. Tighten by hand.
• Choose the nozzle you want to use, pull back
on collar of quick connector, insert nozzle and
release collar. Tug on nozzle to make sure it is
securely in place.
1. Turn fuel shut-off valve to “On”position
(Fig.11).
2. Move throttle control lever to “High” Posi-
tion, shown on engine as a rabbit.
3. Move choke lever to “Choke” position
(Fig.12).
NOTE: For a warm engine, be sure the choke
lever is in the “Run” position.
IMPORTANT: Before starting the pressure
washer, be sure you are wearing adequate
safety goggles.
HOW TO STOP
· Release spray gun trigger and let engine idle
for two minutes.
· Move throttle control lever on engine to
“Stop” position.
· ALWAYS point spray gun in a safe direction.
IMPORTANT: Spray gun traps high water
pressure, even when engine is stopped and
water is disconnected.
NOZZLE
Installing Nozzles to Spray Wand
• Pull slip ring on female quick-connect fitting
of spray wand back.
• Insert male quick-connect fitting on pressure
nozzle into female quick-couple on spray wand.
• Release slip ring on female quick-couple and
twist. Listen for “click” to ensure both quick-
connects are coupled.
• Pull high pressure nozzle and spray wand in
opposite direction to ensure they do not sepa-
rate.
ALERT: To prevent damage to your surface
and to select an appropriate nozzle size for
your application, always start with lowest pres-
sure nozzle size (White) and continue chang-
ing to the higher nozzle size until the best
work result is achieved.
The pressure washer comes furnished with five
spray nozzles. Each nozzle is color coded and
delivers a specific spray pattern and pressure
for a particular cleaning job. The size of the
nozzle determines the size of the fan spray and
the pressure out of the nozzle.
WARNING: Pressure washer produces fluid
pressures and velocities high enough to pen-
etrate human and animal flesh which could
result in serious injury or amputation.
Do not point pressure washer in direction of
people or animals. High velocity fluid spray can
cause objects to break, propelling particles at
high speeds.
0° Nozzle (Red): This
nozzle delivers a pin-
point stream of pres-
surized water and is
extremely powerful.
It covers only a small area of cleaning. This
nozzle should only be directed at surfaces that
can withstand high pressure such as metal or
concrete. Do not use this nozzle to clean wood.
15° Nozzle (Yellow):
This nozzle delivers a
powerful 15 degree
spray pattern for in-
tense cleaning of
small areas.
This nozzle should only be used on areas and
materials that can withstand high pressure.
25° Nozzle (Green):
This nozzle delivers a
25 degree spray pat-
tern for intense clean-
ing of larger areas.
Fig.11
Fig.12
OFF
CHOKE
THROTTLE
FUEL VALVE
Close
Open
Fast
ON
Slow
HG909-HG914 manual.indd 22 02/02/16 5:26 p.m.