URC TKP-7600, Руководство пользователя

Страница: 6 / 44

4
Installation:
The TKP-7600 is wall mountable and fits into a standard dual gang (J-box or Mud Ring)
opening. Prior to installation, make sure power is available at the preferred location.
Power can be supplied to the TKP-7600 through an Ethernet (RJ45) cable connected to a
PoE ( P ower o ver E thernet) in either of the following ways:
●
Router/Switch
● PoE Injector
Power over Ethernet describes a system that passes electrical power safely, along with
data, along Ethernet cabling. A
shielded Ethernet cable is preferred. The IEEE standard
for PoE requires a Category 5 or higher for high power levels.
Using the Spacers:
Use the spacers when installing the mounting ring on to a gang box. The spacers are
NOT needed when using a p-ring.
Included in the box are four (4) spacers that are to be used at specific installation
sites. Most new homes are retrofitted with plaster ring boxes (p-ring) that allow the
TKP-7600 to be mounted flat and flushed to the wall without the user of spacers.
However, in some instances, the only boxes that are in the home are dual-gang
boxes. In those situation spacers are
REQUIRED in order to install the TKP-7600.
Use the spacers as a buffer between the mounting ring and the dual-gang box, this
can be done by using a screw to secure the mounting ring to the box.
With this the TKP-7600 can sit flush and flat on its mount without the risk of
bending or breaking the dual-gang box.
Mounting Ring
Spacers
Dual-Gang