LT-3200 Switch
9
Z-Wave Command Classes
5E - COMMAND_CLASS_ZWAVEPLUS_INFO
26 - COMMAND_CLASS_DIMMER_MULTILEVEL
70 - COMMAND_CLASS_CONFIGURATION
85 - COMMAND_CLASS_ASSOCIATION
59 - COMMAND_CLASS_ASSOCIATION_GRP_INFO
55 - COMMAND_CLASS_TRANSPORT_SERVICE
86 - COMMAND_CLASS_VERSION
72 - COMMAND_CLASS_MANUFACTURER_SPECIFIC
5A - COMMAND_CLASS_DEVICE_RESET_LOCALLY
73 - COMMAND_CLASS_POWERLEVEL
98 - COMMAND_CLASS_SECURITY
9F - COMMAND_CLASS_SECURITY_2
5B - COMMAND_CLASS_CENTRAL_SCENE
6C - COMMAND_CLASS_SUPERVISION
32 - COMMAND_CLASS_METER
75 - COMMAND_CLASS_PROTECTION
22 - COMMAND_CLASS_APPLICATION_STATUS
7A - COMMAND_CLASS_FIRMWARE_UPDATE_MD
Factory Default
You may factory reset the switch by holding down the Config Button for twenty (20) or more seconds. The LED
Bar will turn Red and blink three (3) times to confirm. However, we recommend using a certified Z-Wave
controller to remove the device from your network for factory resetting the switch. Only use either of these
procedures in the event that the network primary controller is missing or otherwise inoperable.
Association Groups
Group 1: Lifeline
Members of this group will receive unsolicited messages related to the status of the switch.
Group 2: Basic Setup
Sends start and stop level change to associated devices.
Grouping Identifier
Max
Nodes
Send Commands
Group 1
0x05
Central Scene Notification
Basic Report
Device Reset Locally
Protection Report
Group 2
0x05
Basic Set
