11/2015
NT BEA-G6EVO
V3.0
EN
p. 36/58
5.4.2. No oil leak – Check Point N°13
Check that there is no oil leak from the hydraulic hose and the cylinder.
5.5. BUILT-IN HYDRAULIC MOTORIZATION CHECK POINTS DETAILS
5.5.1. No contact between bollard head and hydraulic hose – Check Point N°14
Make sure that the hydraulic hose hasn’t moved during the transport. The hydraulic hose must stay in center position and
have no contact with the bollard head part at any time. It is guided and protected by the hydraulic unit support.
5.5.2. No oil leak – Check Point N°15
Check that there is no oil leak from the hydraulic hose and the cylinder.
5.5.3. Proper solenoid valve connection – Check Point N°16
See NT-REVB
5.5.4. Tighten up the fastening screws of the hydraulic pump onto support and support onto casing – Check Point N°17
Check that all assembly screws are well tightened.
Figure 48: Inner bottom view. Hydraulic
hose passing through the bracket
Figure 49: Solenoid valve
indentification
Figure 50: Built-in hydraulic pump
top view
