6.11 Register a wired outdoor sensor
0h
13
1
2
3
10 s
13
13
5
4
24
24
0h
2
10
12
14
16
18
20
C
P
C
AUTO
22
24
4
6
8
6
7
N OT E !
If no button on the controller is pressed for
about 4 minutes, the software exits to run
mode.
To register a wired outdoor sensor to the controller:
1. Press and hold the
OK
button on the controller for
about 10 seconds to enter the system parameters
menu.
2. The settings icon is displayed in the top left hand
corner of the display, and the text
Hot type
,
Cld
type
, or
rEv
type
(depending of current operating
mode) is displayed.
3. Use buttons
<
or
>
to locate parameter
13 (OUSE)
– Outdoor sensor selection.
4. Use buttons
-
or
+
to change parameter settings to
YES
.
5. Press the
OK
button on the controller to confirm
the change and return to the system parameter
settings.
6. Use buttons
<
or
>
to locate parameter
24 (End)
– Exit system parameter settings.
7. Press the
OK
button to exit the system parameters
menu.
To unregister already registered thermostats and/or
sensors, perform a factory reset on both the controller
and thermostats.
See section 8.6 System parameter settings > 23 –
Factory reset for more information about the controller
.
See section 9.4 Factory reset, for more information
about analogue thermostats
.
See section 10.11 Factory reset, for more information
about digital thermostats
.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
3 6
U P O N O R S M AT R I X M O V E / M O V E P L U S · I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L