UPM THM501, Руководство пользователя, Страница: 9 / 34

Press MODE until the HEAT symbol appears and press PROGRAM once. The P1 and SET PROGRAM
symbols will appear on the display.
To select the day that you want to program first, press WEEKDAY until the desired day appears.
(MON, TUE, WED, THU, FRI, SAT, SUN).
Use AHEAD or BACK to select the desired start time for P1.
- Program times can be set in increments of 10 minutes.
- Note: Program times are the same for heating and cooling. The times you choose here will be
used for the cooling program.
Use UP or DOWN (on extreme right) to set the desired temperature for P1.
- Temperature can be set in increments of 0.5°.
- The setpoint temperature range is 5°C to 32°C (41°F to 89°F) for heating.
After setting the desired time and temperature for P1, press PROGRAM again to display P2.
Again, use AHEAD or BACK to set the desired time, and use UP or DOWN to set the desired temperature.
Press PROGRAM to display P3. Repeat above steps to set the times and temperatures for P3 and P4.
To program another day of the week, press WEEKDAY to select the desired day. Then repeat the above
steps to set the desired times and temperatures for P1 to P4.
2
1
3
4
7
5
6
8
7
Heating Program
NOTE: To terminate the programming sequence at any time, press HOME.
NOTE: After the first day is programmed, you can also copy that day to any other day using the
Copy Program function. (Refer to page 8).