6) Place the Connector Sleeve on the Power Lever Connector.
Please refer to the picture above for correct alignment.
7) Carefully insert the Seat Base Tubes into those on the Right Arm
Assembly, while also ensuring that the Connector Sleeve slides over
the Motor Control Rod. This sleeve should be over both the Power
Lever Connector and the Motor Control Rod when assembled to
allow operation of the Risewell lifting mechanism.
8) Move the Seat Base Cover & depress the Locking Pins and ensure
that the Locking Pins in the Seat Base lock into the first hole as
shown.
9) Hand-thread the 1/2” Seat Attachment Screws. Tighten these with
the supplied screwdriver to rigidly attach the Right Arm Assembly to
the Seat Base.
10) For users shorter than 5’2”, remove the leg
extensions. Do this by removing the screw from
the center of leg extension using the supplied
screwdriver.
11) Turn over the assembled chair frame, so the Risewell lifting seat
chair is resting on its legs properly.
12) To attach the Seat Back, hand-thread the 1”
Back Attachment Screws through the brackets
on the chair frame into the pre-drilled holes on
the Seat Back. Use the included screwdriver to
ensure that the screws are tight.
13) To attach the Seat Curtain, plug in your
Risewell and raise the seat using the Power
Lever, then unplug the Risewell power cord.
Connect the velcro strip on the curtain to the
velcro on the underside of the seat.
14) Attach the Removeable Arm Covers.
Attach velcro
strip to seat base
USER GUIDE
10
Risewell User Guide 2011_Risewell Chair User Guide 3/8/2011 2:11 PM Page 6
