© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
9
Step 11 - Caster Installation (optional)
If you purchased Casters for your table, we recommend installing
them now.
A. First, remove the pre-installed Leveling Glides from the Feet by
rotating them counterclockwise to unthread them from the
mounting holes.
B.
Install a Caster in each of the Leveling Glide holes by turning
the stem of the Caster clockwise, threading it into the hole. Use
a 12 mm or ½” flat wrench to tighten Casters that include a hex
nut on the threaded stem for tightening. Tighten firmly.
Step 12 - Keypad Attachment
There are two pairs of Keypad mounting holes pre-drilled into each
main section of the table top to accommodate several different
Keypad designs.
A.
Choose where you’d like your Keypad
(P6)
to be located.
Remember that you are assembling your table upside down,
so the Keypad will be on the opposite side once the table is
upright.
B. Align the Keypad with the pre-drilled table top holes that best
align with the Keypad’s mounting holes.
C.
Using a Phillips Head Screwdriver, attach the Keypad to the
table top with two #10x5/8” Wood Screws
(H14)
. Be careful to
not overtighten to avoid stripping.
P6
H14
P6
H14
P6
H14
H14
P6
Step 13 - Control Box Attachment
A.
Connect the Power Cable
(P7)
into the port on the Control Box
marked “AC”.
B.
Align the Control Box with the pre-drilled holes. Be sure the
“port” indicated by the arrow is facing away from the Crossbar
Rail so it is accessible after installation.
C. Using a Phillips Head Screwdriver, attach the Control Box to the
table top with two #10x5/8” Wood Screws
(H14)
. Be careful to
not overtighten to avoid stripping.
Step 14 - Cable Connections
A.
Connect a Leg Extension Cable
(P8)
to the end of each of the leg
cables.
B.
Connect the other ends of the Leg Extension Cables to the ports
on the Control Box marked M1, M2, M3, and M4.
Note:
Leg Extension Cables can be connected to any port on the
Control Box, there is no specific order. If any of the shorter Leg
Extension Cables do not reach one of the ports on the Control
Box, you can swap it with one of the longer cables.
C. Connect the end of the Keypad
(P6)
cable into the port on the
Control Box marked “HS”.
P5
P7
H14
HS M1 M2 M3 M4
