Table Reset Procedure
IMPORTANT! Before using your table, perform the Initial Table Reset
Procedure below.
Initial Table Reset Procedure
A. Press and hold the DOWN button for approximately 10 seconds,
then release the button. If you have a Keypad with a display, it
will read “RST”.
B. Press and hold the DOWN button again, the table will lower a
little, then rise a little, and then stop.
C.
Release the button. Your table is now ready for use! If you are
using an Advanced Keypad, see the Programming section for
further information on how to use your Keypad.
1
2
3
4
M
Table Placement (Continued)
B. Readjust your grip and continue to rotate the table until it is
rightside up with both Feet completely on the floor.
C.
Position your table where you would like it to be.
Never lift the
table by just the table top, doing so will put undue stress
on the attachment screws. Be sure to hold the frame Side
Brackets when lifting.
•
If your table has Casters:
Moving is easy! If your Casters
include locks, make sure they are unlocked and roll the table
to the desired location. Be sure to relock the Casters to keep
the table stationary.
•
If your table does not have Casters:
Using two people, lift
your table (do not drag it) by holding onto the table top and
Side Brackets together.
D. Adjust the Leveling Glides as needed to level the table.
E.
Check your table’s surroundings to make sure there will be
no obstacles within the table’s path while it is being raised or
lowered. Do not place any objects underneath the table that
are taller than 21” and be aware of any accessories mounted
underneath your table.
F.
Ensure that the Power Cord and all accessory cords are long
enough to accommodate the raising and lowering of your table.
G. Plug your table into a grounded, 120V power outlet.
fig. 2
