Minimum & Maximum Height Settings
The desk frame ships with the Control Box set to the lowest minimum height and the highest maximum height. The
following steps allow the minimum and maximum height limits to be changed to your preference.
Note:
If your desk memory settings were previously set outside of the new minimum and maximum height settings, they
will default to the new minimum and maximum settings. To set new minimum and maximum height settings, you will
need to first remove the current minimum and maximum settings.
To set a new maximum desk height:
1. Move the desk to the desired maximum height pressing the UP or DOWN button.
2. Press the “M” button once, and “S-” will appear on the display. Immediately follow by pressing the UP
button once, so the “S-” flashes once.
3. Hold the “M” button until the display shows “999” then changes to numeric value of new upper limit.
To set a new minimum desk height:
1. Use the UP or DOWN buttons to bring the desk to the desired
minimum
height.
2. Press the “M” button once, and “S-” will appear on the display. Immediately follow by pressing the
DOWN button once, so the “S-” flashes once.
3. Hold the “M” button until the display shows “000” then changes to numeric value of new lower limit.
Removing adjusted maximum and minimum heights:
1. Press the “M” button once and “S-” will appear on the display.
2. Hold the “M” button again until the display reads “555” and then changes to the current
numeric desk height setting.
Programming (Continued)
Display Units
Change the numeric display to show the desk height in either inches or centimeters.
1. Hold the DOWN button on the Keypad until the desk reaches the lowest height, then release.
2.
Hold the DOWN button again until display flashes “RST”.
3. Press the “2” button until display shows “10.3” (centimeters) or “10.4” (inches) and goes back to “RST”.
Note:
While “RST” is still flashing, you can continue to press and hold the “2” button to toggle between the two settings.
4. Hold the DOWN button once more until the desk lowers slightly, then raises slightly, and the display changes back to
the numeric height setting, then release.
