© UPLIFT Desk
• 800-349-3839 • 512-614-3152 • [email protected] • upliftdesk.com
5
Step 1
The Square post feet are designed for Single Sided or
Dual Sided Row configurations as shown in the dia
-
grams.
Regardless of the length of the row of desks, if you are
using UPLIFT V2 and UPLIFT V2-Commercial desks,
the end posts in the run will require End feet. The re-
mainder of the posts in the middle of the row will use
Center feet.
Important note:
The large holes in each of the post
feet are designed to accept the leveling glides at the
back of the UPLIFT V2 and UPLIFT V2-Commerical
desk feet. This patent-pending feature helps to keep
your desks aligned and spaced properly.
For any non-UPLIFT V2 desks, we recommend us-
ing End feet with ALL posts as the larger Center feet
may interfere the feet of other desk styles.
Step 2
Use the M5x10 Flat head screws that were included
with each post to attach the feet as shown to the bot-
tom of each post assembly. The oval power infeed
hole should be facing to the left or right of the foot.
This way the holes will be below the rails.
Hand tighten each screw a few turns at first. Once all
screws are started, tighten them with the included
3mm Allen wrench.
Step 3
Position posts approximately where they will be lo
-
cated once the Power and Data Rail assembly is com-
plete.
We recommend locating one of the end posts in close
proximity to the power outlet (for plug-in power in
-
feeds) or the junction box (for direct-wire power in
-
feeds) with the Power infeed hole facing the power
source.
After the legs are generally where they need to be,
move on to the “Rail Assembly” section.
Parts needed for this part of the assembly
Single Sided Row
Dual Sided Row
Square Post Foot Selection & Assembly
M5x10 Flat head screw
(qty 4)
Dual row center foot
(qty 1)
Single row center foot
(qty 1)
Single row end foot
(qty 1)
Dual row end foot
(qty 1)
Power
infeed
hole
Power
source
3mm Allen wrench
