© UPLIFT Desk
• 800-349-3839 • 512-614-3152 • [email protected] • upliftdesk.com
11
3-Pack
When assembled, the 3-Pack configuration will ac
-
commodate three 120-degree desks. Adjust the Rail
lengths so that they are flush with end of the desks
as shown. This will put the Square post in the proper
location for converting into a Dog Bone configuration
later if desired.
If you are using UPLIFT V2 desks, the Rail lengths
should be adjusted to 42.25” between the 120-Degree
and Square posts.
Note:
We highly recommend using our Desk Bench-
ing System for V2 Desks (FRM028) with 120-Degree
desks to create consistent spacing between the desks.
Dog Bone
The Dog Bone configuration includes two 3-Pack con
-
figurations bridged by pairs of 24” deep rectangular
desks in between. This example illustrates a single pair
of rectangular desks between the 3-Packs.
Assemble the 3-Pack configurations per the instruc
-
tions in the previous section. Then move your Rails
for the rectangular desktops into place between the
3-Packs and adjust the Rail length following the in-
structions on Page 7.
For 3-Pack and Dog Bone Configurations, you will be connecting Rail assemblies between Square posts and
120-Degree Posts. Follow the same Rail extension attachment process as shown in the section “Assembly -
Linear Configurations” Step 3 (page 6).
Assembly - 3-Pack & Dog Bone Configurations
