© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
RESET
10.3
Basic Operation & Programming
Basic Raising and Lowering
Press down and hold the Paddle to lower the
desk. Lift up and hold the Paddle to raise the desk.
Release the Paddle to stop the movement.
RESET
RESET
-14.2
25
24
23
22
21
20
19
18
17
16
25.3
Height Calibration
A. Lower the desk to its lowest position and measure
the height from the floor to the top of the desktop.
B. If the Display does not match the measured height,
begin the reset procedure (see Page 2, Step 6) so
the display reads RESET.
C. Hold the Side Button in for about 5 seconds until a
number displays on the keypad.
D. Press up or down on the Paddle until the number
on the display matches the measured height of
the desk.
E. Wait for the display to again read RESET and then
complete the reset procedure by pressing the
Paddle down and holding until the desk lowers
then rises slightly.
•
Initial height reading for UPLIFT V1 & V2
Frames: 25.3’’
• Initial height reading for UPLIFT V2 Commer-
cial Frame: 22.6’’
Changing Display Units (inches or cm)
A. Begin the reset procedure (see Page 2, Step 6) so
the Display reads RESET.
B. Hold the Side Button and push down on the Pad-
dle to cycle between these numbers:
10.3 Centimeter mode
10.4 Inches mode
C. When the number for your preferred setting ap-
pears, release the Paddle.
D. Complete the reset procedure by pressing the
Paddle down and holding until the desk lowers
then rises slightly.
