9
Notes
1. Main unit calibration must be done prior to wireless device allocation.
2. If required, after the channel is selected, you can calibrate the receiver again only after deleting
the network (quick keys: [9]
>
[1]
>
[8]
>
[3])
=
4.4.2. Registering 2-way Wireless Devices
In order to recognize a 2-way device, the iConnect transmitter must be registered.
It is recommended to register all devices to the control panel before installing. To install
the wireless devices/accessories
temporarily
fit them in the desired locations, and then
perform a range test. Testing may show that you should relocate the panel or some of its
devices/accessories.
4.4.2.1. Detectors
The iConnect supports 34 security zones. Only one detector can be registered to each
zone. Zones 1-32 are intended for wireless detectors while zones 33 and 34 are on-board
hardwire zones.
Notes
1.
The minimum distance between the detectors and the panel should be 1.5m.
2.
Once a detector is deleted from the panel it must be followed by the deletion of the panel in the
detector. If this is not done, it will lead to an "out of Sync" situation
by design
Step 1: Register a detector
1.
Go to the main menu select
[9]>[1]>[1]
(Programming
>
Devices
>
Zones)
2.
Using the arrow keys, select a specific zone and press
'√'
. The system initiates
Registration mode.
3.
Send a transmission from the detector using the following method:
Open the detector's housing (tamper should be open)
Apply battery power. The detector will send a transmission. If the transmission
is successfully received by the system it will play a confirmation sound. If no
confirmation sound is heard send another transmission by pressing and
releasing the tamper switch of the device
.
4.
After the detector is successfully registered the display shows:
'Save
?'.
Press
'√'
to confirm and continue entering other parameters for the chosen
device (see section below). It is possible to press
'X'
to go back and enroll
additional zones.
Step 2: Set detector's parameters
1.
Go to the main menu select
[9]>[1]>[1]
(Programming
>
Devices
>
Zones)
2.
Using the arrow keys select a specific zone and press
'√'
.
3.
Set the main parameters for each zone, according to the
Table 2
.
