3
1.
Introduction
Thank you for choosing
iConnect
wireless intruder control panel. This quick start
guide manual describes the main steps for installing and programming the iConnect
Control System using the keypad on the main unit.
2.
System Installation
1.
Open the main unit housing.
2.
Place the rear main unit against the wall and mark the upper and lower
mounting holes.
Note
If required, mark the rear tampers' location. It is located behind the main board.
3.
Install wall anchors in the appropriate positions
4.
Thread the power cable through the wiring hole on the back cover and connect
the cable to the AC power input on the main board.
Caution
Do not apply AC power at this stage.
5.
If required connect a network (IP) cable and/or insert a SIM card to the
GSM/GPRS module.
6.
Connect the battery pack to the connector. If an alarm occurs, insert the master
user code number (default '1234') to silence the alarm.
7.
Mount the control system to a wall.
8.
Close the front cover and apply AC power.
Note
It is recommended to perform a system scan in order to verify the system configuration. A
system scan is performed from the main menu:
'[9]
Programming
' > '[7]
Initialize'
> '[5]
Find Modules
' > '
√
'.
The generated list displays the recognized system elements. If an
element is not included in the list, check the wiring connections and run this scan again.
