UP Profile 2 - 20, Руководство владельца и сервисная книжка

Страница: 22 / 42

___________________________________________________________________________
Installing the
UP Profile 2 in a
harness
The UP Profile 2 can be used in
conjunction with most approved
harnesses on the market, but UP
cannot guarantee that it will function
perfectly with every available harness.
WARNING! Always make sure
that you perform a
compatibility test
harness/reserve when
you have installed your
reserve in the harness. This
is done by hanging the harness
in a flying position, buckling up and
then deploying the reserve. If there is
ANY PROBLEM the harness/reserve
combination may be dangerous to fly!
Should you still have doubts or
questions we suggest that you contact
your UP dealer or UP directly.
Mounting the
UP Profile 2 outer
container on your
harness
If you fly a harness without a built-in
reserve container you can mount the
UP Profile 2 in its outer container on
the harness.
First connect the UP Profile 2 bridle
with the harness’ reserve bridle, using
the special “handshake” knot.
Then attach the outer container left or
right, using the Velcro connectors on
the back of the outer container. Make
sure it is securely attached and that it
does not obstruct any other part of
your flying equipment, like speedbar or
harness adjustments.
Installing the UP
Profile 2 in a harness
with integrated reserve
container
When installing the UP Profile 2 in a
harness please follow the user manual
delivered with the harness. The
following directions must however
always be adhered to:
•
Use only the original deployment
handle delivered with the harness.
Using other handles will
compromise your safety
•
If your inner container has an
asymmetrically located
attachment loop for the
deployment handle make sure
that you turn the inner container in
such a way that the attachment
loop is orientated towards the
direction of the deployment pull.
Failing to do so may render your
parachute un-deployable
•
Also make sure that the
connection between handle and
pin is shorter than between handle
and inner container. If the
opposite is the case you may find
yourself pulling on the container
when attempting to deploy,
without releasing the pin
•
Attach the deployment handle in
such a way that the connection
band is not fully stretched out –
this could result in involuntary
deployment because the pin could
get pulled out
•
After each repack the whole
system must be tested and tried;
see “Compatibility check” above!
22