Gas burning pizza brickoven
R-001 100518
Page 30 of 33
Recommended time interval: once every 10 years
Manufacturer's Technician:
the qualified technician who has been designated
by the manufacturer to carry out complex operations in specific situations or, in
any case, on the basis of what has been agreed upon with the user. Depending
on each case, the personnel is requested to have mechanical and/or electrical
and/or electronic and/or IT skills.
Type of intervention: Inspection and adjustment of the baking deck and internal dome.
10. TROUBLESHOOTING
-
bLc / rSt messages displayed
: Burner needs a manual reset.
In order to reset, press and hold the red button above to the console
for 2
seconds
, then release it. The displayed error will disappear and you can try again
to start it up. This problem is caused by detection probe failing flame check during
normal operation or ignition process. The problem is often cause by gas supply
being closed during ignition operation; if that is the cause, open the gas knob, reset
the error with the procedure described above, and turn the oven on again.
-
HHH message on display
: Max temperature has been exceeded
-
EEE blinking message on display
: Thermocouple reading problem, verify
connection or call assistance for help.
-
Gas flame is low even at maximum level
: check that inlet pressure is set
according to the requested value and that the correct nozzle for your type of gas is
installed. Also verify max/min valve regulation according to the procedures
described in this manual.
-
Irregular gas flame
:
check that the installed nozzle is the correct one for the gas
type you are using. Also regulate max/min values according to the nominal values
stated in the manual.
-
I have problems reaching higher temperatures
:
verify that the extraction system
is correctly set for you type of gas. If the extraction is too strong the oven might
face problems reaching the higher temperatures.
If the suggested operation did not solve the malfunctioning, interrupt the
operation and ask for help to the customer support center.
Do not open the equipment's external covering if you're not expressly
authorized in writing by
Univex
or any of his authorized maintenance
services.
The
non-observance
to this
rule
will
lead
to the
immediate invalidation of the warranty and of the retailer's ensuing
responsibilities for aspects concerning safety and functioning.
