6509
9.
Turn slicer OFF. Loosen lock pin, then lift and return sharpener to its storage position. Tighten lock pin.
10.
Clean slicer and knife according to the cleaning procedure on Page 7 in order to thoroughly remove
grinding debris.
OPERATORS CARE OF SLICER
CLEANING
1.
Warning:
Never touch the knife. Always keep your hands, fingers and arms clear of knife.
2,
Warning:
Turn off slicer and DISCONNECT ELECTRICAL CORD (Fig. 1 |13|) before cleaning. Leave
knife guard in place.
3.
Turn slice adjustment knob (Fig. 1 [8]) to the fully closed position (beyond "0") so that the knife edge is
not exposed.
4.
Caution:
Remove carriage assembly (Fig. 1 [121) which may be washed in a sink. Use care in washing
the sharply pointed prongs on the last slice feed grip. Wash this area thoroughly. A small bristle brush is
recommended. Use only warn water and mild soap. Rinse carriage assembly with warm water and dry
thoroughly using a clean soft cloth.
Never use detergents nor wash the slicer or any of its parts in a dishwashing machine or the clear
protective finish will be damage.
5.
Warning:
Wash body of slicer using warm water and mild soap using a soft cloth. Rinse using a clean,
soft cloth. Under no circumstances should the slicer be hose rinsed. It is recommended that the cloth be
folded over a thin wooden stick when cleaning between the fence plate and the knife.
6.
Remove knife guard (Fig. 1 [3]) by loosening knife guard knob (Fig. 3 [64 ]) and pushing the long stud
upward to lift knife guard above surface of knife. Then carefully lift and remove guard.
7.
Warning:
CAREFULLY wash the front and rear of the knife with a cloth using warm water and mild
soap. It is recommended that the cloth be folded over a thin wooden stick as a further caution to avoid
accidental contact with the knife Rinse with warm water applied with a cloth. Dry thoroughly with a clean
soft cloth
8.
Caution:
Following cleaning, a commercial non-toxic sanitizer may be wiped on the clean surfaces with a
soft clean cloth or sprayed as recommended on the container labeling. It is important that the sanitizer be
compatible with anodized aluminum or the clear protective finish on the slicer will be damaged. Surfaces
should be wetted completely, but not to the point of running or puddling.
9.
Warning:
Replace the knife guard. Never leave the slicer without its knife guard installed!
PAGE 6
