6509
11. Reinstall knife, knife guard and sharpener in the reverse procedure outlined above.
SHARPENING STONES
1
Disconnect electrical cord.
2. Unscrew sharpener lock pin (Fig. 3 [4])-
3. Lift up sharpening assembly (Fig. 1 [2]) and remove from slicer.
4. Using an open end wrench, unscrew cover knob (Fig. 3 [23]). It is recommended that a piece of tape or
paper be temporarily wrapped around knob prior to unscrewing it so as to protect its finish.
5. Gently remove sharpener cover (Fig. 3 [22]) off of mounting block (Fig. 3 [27]). Perform this step slowly
taking care to remove cover evenly from the two locating pins on which it fits snugly.
6.
Unscrew nut (Fig. 3 (1 1|) and remove along with washer and sharpening stone (Fig. 3 [9]).
7. Install new sharpening stone. Flat face should be toward the outside.
8. Honing (deburring) stone (Fig. 3 [18]) is removed by first unscrewing lock screw (Fig. 3 |13j) from thimble
(Fig. 3 [12]).
9. Gently remove thimble taking care to not lose the small ball bearing and spring (Fig. 3 [14 & 15]) which
are inside.
10 Unscrew nut (Fig. 3 [16]) and remove along with washer and honing stone (Fig. 3 118]).
11. Install new honing stone with the flat face toward the inside.
12. Reattach cover and reinstall in the reverse procedures (5 through 1).
REPLACEMENT OF PARTS LISTS
Replacement parts for the Slicing Machine are shown in the following figures. When ordering replacement parts,
always include the model and serial numbers of the machine in addition to the specific part number.
PAGE 13
