Goodrive10 inverters Keypad operation procedure
22
Serial
No.
Name
Description
Entry
key
Enter the menu step-by-step
Confirm parameters
UP key
Increase data or function code progressively
DOWN
key
Decrease data or function code progressively
Right-s
hift key
Move right to select the displaying parameter circularly in
stopping and running mode.
Select the parameter modifying digit during the
parameter modification
Run
key
This key is used to operate on the inverter in key
operation mode
Stop/
Reset
key
This key is used to stop in running state and it is limited
by function code P07.04
This key is used to reset all control modes in the fault
alarm state
Quick
key
The function of this key is confirmed by function code
P07.02.
4.1 Keypad displaying
The keypad displaying state of Goodrive10 series inverters is divided into stopping state parameter, running
state parameter, function code parameter editing state and fault alarm state and so on.
4.1.1 Displayed state of stopping parameter
When the inverter is in the stopping state, the keypad will display stopping parameters which is shown in
figure 4-2.
In the stopping state, various kinds of parameters can be displayed. Select the parameters to be displayed or
not by P07.07. See the instructions of P07.07 for the detailed definition of each bit.
In the stopping state, there are 14 stopping parameters can be selected to be displayed or not. They are: set
frequency, bus voltage, input terminals state, output terminals state, PID reference, PID feedback, AI1, AI2
and the current stage of multi-stage speeds, pulse counting value. P07.07 can select the parameter to be
displayed or not by bit and
》
/SHIFT can shift the parameters form left to right, QUICK/JOG (P07.02=2) can
shift the parameters form right to left.
