Universal Laser Systems VLS2.30, Руководство пользователя

Страница: 75 / 99

Cutting Table
The cutting table is used to support material when cutting so that exhaust flow is redirected both above and below
the material for clean cuts. Without it, smoke and debris can build up underneath the material causing the surface
of the material to be damaged. The cutting table also helps to reduce damage to the surface of the material from
laser back reflection which can occur when the laser reflects off of the table supporting the material if you attempt
to cut without the cutting table.
Installation
1.
Turn on your laser system.
2.
Lower the engraving table to the bottom of its travel.
3.
Remove the engraving table by loosening the two captive thumbscrews (1). Then, using the finger holes
(2), carefully lift the table out of the laser system.
4.
The table support platform underneath contains a self-aligning electrical connector (1) and the two
alignment pins (2).
75