Revision date: 23 09 2014
Page 10 of 32
5 FRONT PANEL
1. Wire speed adjustment. See separate table under OPERATION for relation between wire speed and
approximate welding current. This adjustment is only active when one of the wire welding modes are
selected
2. When this LED is lit, it means that the thermal cut-out for overheating of the machine has triggered
and there is no welding current. Do not switch the machine off. The fan will be running and the
thermostat resets automatically when the machine has cooled down sufficiently. The light will darken
when the machine is live again.
When the machine is switched on, this LED is lit for five seconds, during which time there is no
welding current available.
3. Power on. When this LED is on welding current is available. In MMA (stick electrode) welding mode
the open circuit voltage of 10V is present b and
– terminals.
4. Warning light indicating live terminals
5. Welding current / voltage adjustment. The green scale A 5-140 show selected amperage for MMA
(stick electrode) welding. The white scale V 10-26 show selected voltage for MIG (wire) welding
6. Wire feed function. By pressing this knob wire will be fed through to the torch without being
electrically live.
1
2
3
4
5
8
7
6
