Unitor UPC 85 ML, Инструкция по эксплуатации

Страница: 10 / 24

10
START-UP
1
.
The red led (2) is illuminated and the unit is now in STAND-BY. In order to perform plasma cutting
operation, please follow the following steps:
2.Set the output current (7) to a suitable value for the thickness that is to be cut. For thin materials reduced
output may be required to obtain a smooth and neat cut.
3.Before cutting, press the RESET button (9). The red led (2) is now off and you are ready to cut. If
the RESET button is not pressed the unit will remain on STAND-BY mode.
THIS IS A SAFETY DEVICE!
CAUTION: If AIR TEST button (3) is pressed before RESET button (9), you need to allow the air to
flow out until it stopped completely (about 20 seconds)
, or pressing it (AIR TEST button (3)) again to
stop it, before pressing the RESET button (9). If RESET button (9) is pressed during air flowing out,
the machine will return error message “PIP” (For Safety Protection) and machine need to be re-
started before use again.
1.The Inverter is now ready for work. When you want to start, position the torch on the work-piece to be cut
and slide the trigger release toward the back of the torch and press the trigger. An air preflow of 2 seconds
will come before the pilot arc starts.
2.The arc is transferred to the work-piece and cutting will start. Move the torch in the desired direction at a
speed that ensures a good cutting quality.
3.When the cut is finished, release the torch trigger to stop the arc.
4.Air will continue to flow out for about 15 seconds to cool the torch parts.