UNITED CPC 12000, Руководство по эксплуатации и обслуживанию

Страница: 14 / 45

Page | 14
Do not let parts sit for an extended period after finishing. Some materials, especially aluminum and
zinc alloys will develop corrosion spots if left in the machine for as little as 10 minutes after the end of
the process. If the parts have sat in the barrel, operate the CPC for a few extra minutes before
unloading the barrels. This may help eliminate spotting that may have developed.
Never put compound directly on work pieces. Always load media and water on top of parts before
adding compound or compound residue may be found on the parts.
Thoroughly rinse the empty barrels between process steps.
Never use the same scooper for more than one compound. Doing so will contaminate both products
and may result in inferior finishing.
Keep finishing media as clean and uncontaminated as possible.
Avoid inadvertently mixing media together.
If the work pieces are subject to rust, a rustproof treatment must be used.
4.4 Auto Operation using the CPC Interface
In addition to the MAINTENANCE and SYSTEM HELP this chapter will cover the AUTO mode of
operation and recipe storage for the CPC. Please refer to the previous chapter
4.3 Manual Operation
for operation procedures when using the manual mode of operation.
Select AUTO OPERATION to display the Preset Processes screen shown in Figure 4.7 on the next page.
This control screen allows the operator to store, edit, review or run any of the 30 allowable preset
processes.