Page | 13
Remaining Cycle Time
Below the Preset Time display on the
Manual Operation
screen is a
countdown timer labeled in blue lettering. This timer will display the time
remaining until the cycle is complete. If the CPC is stopped during a cycle
the Remaining timer
will retain the remaining cycle time until the shutter door is opened, at
which time the display
will reset to the
preset time
. By pressing the touch key next to the remaining timer the timer can be
reset to the PRESET TIME while the system is in operation.
4.3.12 Unloading the System
When the system has completed the process cycle, the turret will automatically decelerate and stop,
the STOP touch key will be illuminated red, and the shutter door will automatically open. At that time,
follow these operations to safely unload the CPC.
1.
The system goes into
Jog Mode
once the shutter door is completely open.
2.
Use the jog controls (Figure 4.3) in conjunction with the Jog button to bring the first
barrel to be unloaded into position. Open the barrels as described in
4.3.5 Opening
Barrels
.
WARNING: Refer to the
4.3.6 Heat Precaution
for important safety information.
3.
Start the Material Handling and Parts/Media Rinse Systems as described in
4.3.8
Material Handling
. The
Rinse Controls
are located in the lower left hand corner of the
screen.
4.
Empty the barrel by rotating the barrel and dumping the contents onto the forward
splash panel. This will allow the parts to lay flat before sliding onto the separator screen.
5.
Reload the barrel for the next process or step of operation as described in
4.3.7
Loading Barrels
.
6.
Replace the barrel lid and secure the locking pin as described in
4.3.9 Closing Barrels
.
7.
Repeat the unloading and reloading sequences for the next barrel.
4.3.13 Operating Tips
Here are a few additional tips for working with your CPC that should make production easier and
more consistent:
Always use a soap or detergent in every process. Otherwise the media will soon take on a glazed
appearance and will no longer cut properly.
Rinse parts after each step of the process. Do not let the compound dry on the parts.
Содержание CPC 12000
Страница 1: ...CPC 12000 Operation and Service Manual ...
Страница 33: ...Page 33 5 8 Adjusting Idler Assembly ...
Страница 39: ...Page 39 ...
