GB│IE
│
11
■
UAV 300 A1
Troubleshooting
If there is a jam in the appliance
This means that you may have attempted to feed too much paper into the appli-
ance (max. 10 sheets 80 g/m
2
paper).
♦
Move the
REV/OFF/AUTO/FWD
switch
3
to the
REV
position if the paper
causes a blockage. The appliance now goes into reverse and the material is
ejected.
♦
Alternatively, move the
REV/OFF/AUTO/FWD
switch
3
to the
FWD
position if the paper causes a blockage. The appliance is now in forwards
operation and the material that is being shredded is pulled in again.
♦
Pull the paper out of the appliance and then move the
REV/OFF/AUTO/
FWD
switch
3
to
AUTO
.
The appliance is now ready for use again.
If the appliance suddenly stops working
This means that the appliance has overheated and the automatic safety cut-out
has activated itself. The
overheat
lamp
5
lights up permanently red.
♦
Move the
REV/OFF/AUTO/FWD
switch
3
to the
OFF
position.
♦
Remove the plug
1
from the mains power socket.
♦
Allow the appliance to cool down for about 30 minutes.
♦
Replace the plug
1
in the mains power socket.
♦
Switch the appliance on by moving the
REV/OFF/AUTO/FWD
switch
3
to the
AUTO
position. The power lamp
4
lights up permanently blue.
The
overheat
lamp
5
remains off when the appliance has cooled down
sufficiently.
If the appliance cannot be switched on
♦
Make sure the cutter attachment
6
is seated correctly on the large waste
collector
w
.
♦
Try a different socket.
♦
The appliance is possibly defective. Have the appliance checked by a
qualified technician.
♦
The appliance has overheated and triggered the automatic safety cut-out.
Proceed as described in the section above If the appliance suddenly stops
working.
Содержание 385039 2107
Страница 3: ...power overheat...
Страница 49: ...46 FR BE UAV 300 A1...
Страница 177: ...174 SI UAV 300 A1...