background image

IMT120 15

180 Dexter Avenue 

Watertown, MA 02472 - USA

Telephone: 617 926-1000 - Fax: 617 926-2568

www.ueonline.com

FOR A LIST OF OUR INTERNATIONAL AND 

DOMESTIC REGIONAL SALES OFFICES 

PLEASE VISIT OUR WEBPAGE

WWW.UEONLINE.COM

LIMITED WARRANTY

Seller warrants that the device hereby purchased is, upon 

delivery, free from defects in material and workmanship and 

that any such device which is found to be defective in such 

workmanship or material will be repaired or replaced by Seller 

(Ex-works, Factory, Watertown, Massachusetts. INCOTERMS); 

provided, however, that this warranty applies only to device 

found to be so defective within a period of 24 months from the 

date of manufacture by the Seller. Seller shall not be obligated 

under this warranty for alleged defects which examination 

discloses are due to tampering, misuse, neglect, improper 

storage, and in any case where devices are disassembled by 

anyone other than authorized Seller’s representatives. EXCEPT 

FOR THE LIMITED WARRANTY OF REPAIR AND REPLACEMENT 

STATED ABOVE, SELLER DISCLAIMS ALL WARRANTIES 

WHATSOEVER WITH RESPECT TO THE DEVICE, INCLUDING ALL 

IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR 

ANY PARTICULAR PURPOSE.

LIMITATION OF SELLER’S LIABILITY

Seller’s liability to Buyer for any loss or claim, including liability 

incurred in connection with (i) breach of any warranty 

whatsoever, expressed or implied, (ii) a breach of contract, (iii) 

a negligent act or acts (or negligent failure to act) committed 

by Seller, or (iv) an act for which strict liability will be inputted 

to seller, is limited to the “limited warranty” of repair and/or 

replacement as so stated in our warranty of device. In no event 

shall the Seller be liable for any special, indirect, consequential 

or other damages of a like general nature, including, without 

limitation, loss of profits or production, or loss or expenses of 

any nature incurred by the buyer or any third party.

UE specifications subject to change without notice.

Содержание 120 Series









Отзывы: