3.1.6. Detect-antennas
The option of Detect-Ant helps you to figure out the connection of all antennas, as shown in
Fig. 23. While detecting, this option enables all antennas and changes its text to dot-dot-dot
to let you know that it is still processing, as shown in Fig. 24. After detected, this option
revises your previous setting to fit the real status of antennas, as shown in Fig. 25.
Fig. 23. Detect the available antennas
Fig. 24. Detecting the available antennas
Fig. 25. Detected the available antennas
3.1.7. Power-level
The Power-level option allows you to globally configure the power level of all antennas in
units of dBm, as shown in Fig. 26. Moreover, if the entered value is over the limitation of the
hardware, which shows in the angle brackets, the option will limit it to the range.
Fig. 26. Configuring Power-level
3.1.8. Dwell-time
The Dwell-time option allows you to globally configure the dwell time of all antennas in
milliseconds, as shown in Fig. 27. In addition, this option restricts your input value to the
regulation of the region that shows in the angle brackets and Table 5. Moreover, as you know,
the duration of an inventory is relative to both the dwell-time and the inventory-cycles, so that
one of them must not be zero. Therefore, this option will remain unchanged if both the
entered value and the inventory-cycle is zero.
Fig. 27. Configuring Dwell-time
17
