![background image](http://html.mh-extra.com/html/unitec/lw-1100r/lw-1100r_operation-manual_844147002.webp)
13
roller, the film will be wrapped around the rollers. Thread the film in proper
position.
The laminating temperature is too high, the film will be melted and wrapped
around the roller. Decrease the laminating temperature.
Press the STOP button immediately. After the roller cool down, cut the film on
the top and bottom, just in front of the stabilizer bars Reverse the roller at a very
low speed and allow the machine to back out the film that is wrapped around the
Wrinkling of the plastic on a laminated material.
Check the tension of the film, make sure the film is threaded
properly (see film threading).
Film is not properly adhered.
The laminating temperature is too low, there is not enough
heat for melting the adhesive. Increase the laminating temperature.
The laminated material seems to have a irregular surface that
does not match the texture of the paper being coated.
This is usually caused by adhesive build-up or dirt on the
rubber rollers. Inspect the rubber rollers and clean it.
Damages to the rubbers can also cause irregularities in the surface of the
film.
General haziness or cloudiness in the film after lamination.
Increase the temperature or decrease the speed. That
cloudiness is a function of incomplete adhesion. On a variable speed
machine loaded with thicker film, it may be that the film is being run too
fast.
If the service is required, please provide the following information:
The detail of the problem
Installation Date
Serial number
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
For problems not listed here, contact your local dealer.
SERVICE
1
3
4
7
10
11
13
14
SAFETY PRECAUTIONS
STRUCTURE AND CONTROL PANEL
FUNCTIONS OF DIGITAL DISPLAY,
CONTROL PANEL AND EMERGENCY STOP
OPERATION INSTRUCTIONS
Preparation
Hot laminating
Cold laminating
MAINTENANCE AND SERVICE
SPECIFICATION
INSTALLATION
Thank you for purchasing and using our laminator.
You have purchased the finest laminator available in its service class. It was
designed and manufactured to provide you with the utmost in utility. As
with any device that combines power and movement in its use, there are
dangers if improperly used. At the same time, there are easier and fast er
ways for getting the job done if certain precautions are taken first. Please
read this manual carefully. It contains useful ideas in obtaining the most
efficient operation from your laminator and safety procedures you need t o
know before beginning use. Save the manual for later use.
CONGRATULATIONS
MAINTENANCE AND SERVICE
5
文件使用
"pdfFactory Pro"
试用版本创建
www.fineprint.cn