![background image](http://html.mh-extra.com/html/unitec/lw-1100r/lw-1100r_operation-manual_844147006.webp)
Step 8: Push the FWD button. If the film and the card are in the nip (the point
where the top and bottom roller meet), the film and the threading card will start
into the laminator and will pass through both sets of rubber rollers. When the
threading card has cleared the back of the machine, press the STOP button.
Step 1: Raising the safety shield.
Remove the active bolt on the shield, raise the safety shield.
Step 2: Follow the diagram to thread the film
Slide the roll film onto the roll shaft (follow the above instruction, do not load
the film in wrong side). Hold the roll film on the core adapter, the core adapter
can hold the core of the roll film, to prevent it rotating. Screwing the bolt on the
core adapter. Put the rolls on the brackets. Make sure it is fully seated.
Step 3: Insert a piece of wide cardboard (guiding paper) between the rollers. the
width of cardboard should be larger than the width of cold film. Pull the film
from the top roller passing over the top stabilizer bar to the top roller.
Step 4: Put the paper back of the cold film to the bobbin at take-up bar to rewind
the paper back. Allow some of the cold film with melted resin to stick the wide
cardboard (guiding paper).
Step 5: Position the safety shield forward toward the roller and lock the active
bolt.
Caution: For operator safety, the safety shield must be in position over the
upper heating roller when the machine is ON, or the FWD button is pressed.
Remark: The machine will not power on without the safety shield in the
proper positions.
COLD FILM
9
4
1
2
3
,
4
5
.Upon receipt of the laminator, inspect of box, the machine and all other
contents of the box for shipping damage. Shipping damage should be brought to
the immediate attention of the delivering carrier.
.The laminator comes fully assembled on a stand .
.Screw the wheel on the stand put the stand upright. Place the middle
supporting beam horizontally, connect the beam and stand with the bolt which
has spring washer on it, then fasten it.
.Put the laminator on the assembled stand.
.Start operation after turning the wheel stop switch to "OFF".
WARNING: The four nuts on the top of wooden case, are used for fixing the
machine stand inside the case. While disassembling the case, DO take out
the fixing nail which connect the top cover and the bottom base FIRST, then
remove the top cover, open the wooden case. LAST, unscrew the fixing bolt
and take out the machine stand. DO NOT loosen the fixing bolt before open
the wooden case, in case the inside machine stand drop onto the machine
and damage it. The supporting beams are inside the box.
INSTALLATION
OPERATION INSTRUCTIONS
Top heating roller
Bottom heating rolle r
Cold film
Top stabilizer bar
Top pull roller
Bottom pull roller
Take-up bobbin
Back pa per
STAND ASSEMBLY
S uppo rtin g be am
Left stand
Righ t sta nd
文件使用
"pdfFactory Pro"
试用版本创建
www.fineprint.cn