Please read these operating instructions carefully before using the torque wrench.
Keep the instructions in a safe place.
Pass on all documentation when passing on the torque wrench to another person.
A)
Hold the wrench in the left hand,
looking at the graduated scale, then
release the knurled handle by turning
the knurled screw anticlockwise. See
Fig. 1.
B)
Set the required torque precisely
using the scale on the housing.
Example: 86 ft.lbs.
1.
Rotate the knurled handle until the
0 mark on the chamfered edge of
the handle points to the vertical
marking on the housing and is flush
with the scale value 80 ft.Ibs.
2.
Rotate the handle clockwise until the 6 ft.Ibs. marking on the chamfered edge of
the handle points to the vertical line on the housing.
3.
Lock the handle by turning the knurled screw clockwise.
The wrench is now set for a torque of 86 ft. Ibs. and is ready for use. See Fig. 2.
C)
Make other settings (Nm) in the same manner as when making settings using ft.lbs.
D)
Attach the appropriate socket or other tool on the external square, then place it on the
socket or bolt. Rotate the handle until the wrench audibly or perceptibly engages.
When you loosen the tension and release the wrench, it automatically resets itself
for the next use.
Do not tighten any further after the wrench is engaged. Ensure, particularly when
the torque values are low, that no further tension is applied after the wrench has
engaged.
1.
If the wrench has not been used for a while or has been in storage, operate it several
times with a low torque so that the special internal lubrication system can wet the
moving parts inside with lubricant.
2.
When not in use, set the wrench to the lowest torque.
3.
Do not rotate the handle past the lowest torque.
4.
Do not continue to pull on the wrench after the preset torque has been reached and
the wrench is engaged. The pressure must be removed from the handle and the
wrench so that it can automatically reset itself. Further pressure after the wrench is
engaged will lead to the tightened section being damaged by excessive torque
5.
The tool is sturdy and is designed for workshop operation, but it is a precision
measuring instrument and must be handled accordingly.
6.
Clean the wrench by wiping it off: Do not immerse in any kind of cleaning agent;
this can affect the special lubricant filled into the wrench at the factory.
7.
The torque wrench was calibrated and verified before leaving the factory and
is accurate to +4%.
This is a precision measuring instrument.
The owner is responsible for regular calibration and maintenance.
Length:
444-470 mm (10-210 Nm)
Weight (without accessories): 1.1 kg
Torque:
10-210 Nm
Setting the release torque
Safety
Using your
new torque wrench
Attention!
Cleaning information:
Technical data:
Fig. 1
Fig. 2
20807-09_UNI-IM-INT-OEF_A5_170116.indd 3
16.01.17 16:15
