value will be displayed.
5.5
C/F
button
mode.
The default temperature units of measure are degrees Celsius. To toggle between degrees
Celsius and degrees Fahrenheit, press and hold the
C/F(WiFi)
button while in normal mode.
In normal mode,press and hold the
C/F(WiFi)
button for three seconds, the console icon(in front
of the indoor temperature)
will flash to signify that it has entered WAP (wireless access
point) mode, and is ready to enter for WIFI settings.
5.6
Snooze
Mode
When the alarm sounds and alarm icon
flashes, press the
SNOOZE/LIGHT
key to temporarily silence the alarm for
five minutes.
The snooze icon
will continue to flash , after five minutes, the alarm will sound again. This will continue until the
alarm is turned off. press any key (
SET, Min/Max/-,C, C/F
) to permanently exit the
Snooze
mode.
5.7
Back
light
Mode
If the LED is off, press the
LIGHT
button once. The backlight will turn on for five seconds, and if no operation is
performed for three seconds, the backlight will turn off.
Press and hold the
LIGHT
key for two seconds, and the backlight will turn on permanently, and display
BL ON
icon will
be displayed for three seconds in the time field.
To turn off the backlight at any time, Press and hold the SNOOZE/LIGHT key for two seconds, and
BL OFF
icon will
be displayed for three seconds in the date field.
Note: If plugged into AC power, the time area will display AC ON and the backlight will remain on. It is not
recommended leaving the backlight on for a long period of time when operating on batteries only, or the batteries will run
down quickly.
5.8
RF
receiving
signal
prompt
In normal mode, the signal is interfered by many factors. When there is no signal, the signal is not connected to the base
station. The signal is from no signal to weak signal to good signal, as shown: weak signal
and good signal
.
5.9
Adjustment
or
Calibration
Note:
The calibrated value can only be adjusted on the console. The remote sensor(s) always displays the
un-calibrated or measured value.
