FT0851 Wireless 3 Channel Weather Station with WiFi Remote
Monitoring User Manual
1
Introduction
Thank you for your purchase of the FT0851 Wireless 3 Channel Weather Station. The following user guide provides step
by step instructions for installation, operation and troubleshooting.
2
Getting
Started
The FT0851 weather station consists of a display console (receiver), and three thermo-hygrometers (remote transmitters).
Note:
The power up sequence must be performed in the order shown in this section (insert batteries in the remote
transmitters first, Display Console second).
2.1
Parts
List
The FT0851 weather station consists of the following parts (as referenced in Figure 1).
QTY Item
1 Display
Console
Frame Dimensions (LxHxW): 135X195X26mm
LCD Dimensions (LxW): 112 x 63mm
3 Thermo-hygrometer
sensor
1 Adaptor
1 Manual
Figure 1
2.2
Sensor
Assembly
Set
Up
Note:
To avoid permanent damage, please take note of the battery polarity before inserting the batteries.
Pull down on the battery door to open the battery compartment, as shown in
，
Insert two fresh AAA batteries (with the
negative terminal of the battery in contact with each spring). Lithium batteries are recommended for cold weather
environments. Slide the top lip of the battery door into the battery compartment guide and snap the bottom battery door
bracket into place. The LED shown in will light up (visible through the plastic).
