Unique Prestige UGP-24V PC1 B, Инструкция по установке и эксплуатации

Страница: 28 / 54

28
Cooktop Burner Operation
The top burner flame size should be adjusted so
that is does not extend beyond the edge of the
cookware. As a matter of safety, it’s recommended
that you comply with these instructions.
A high flame on a surface burner is both inefficient and unsafe. The flame should
always be adjusted so that it is no larger than the bottom of the pan. Fluctuations
in flame size could be caused by pressure variations, improperly positioned burn-
ers, damage or debris.
To light a burner, press the burner knob in and turn counter clockwise to
high flame/ignition position. You will hear the electronic ignition clicking as
you continue to hold the knob down until the flame lights. ALL electrodes will spark
at a rate of approximately 2 ½ pulses (sparks) per second. Once the burner
is lit, hold in for a few extra seconds to warm up the thermocouple so the
electromagnet in the burner valve stays in the open position once you release.
Continue to hold the knob depressed until gas ignites at the burner. Adjust the in-
tensity of top burner heat in the same manner described above.
Note: In the event the electronic ignition system fails, the top burners and oven
pilot can be lit by holding a lighted match near the burner head and turning the
appropriate top burner knob to the “9 o’clock position”.
TOP BURNER HEIGHT
ADJUSTING THE TOP BURNER AND OVEN FLAME
(continued)
incorrect and good flame patterns