GPS RECEIVER
resellers, these units are WAAS/EGNOS enabled unless otherwise stated. Accuracy can be up to 2
meters with WAAS enabled and 2.5 meters 2D RMS WAAS disabled
What is ideal GPS environment?
The GPS requires an open, clear view of the sky. Buildings, covered parking areas, tunnels and dense
foliage can cause the GPS receiver to be unable to get a location fix.
If you are parked in a covered parking lot or near a tall building, it is recommended that you drive away
until you have a clear view of the sky before using the GPS receiver. You may need to give the GPS
a few minutes to find or get a fix its location.
How do I know if the GPS is ON?
Your USB GPS must be plugged into your laptop’s USB port to get power. If your PC is on and the
COM port was configured properly, the GPS receiver is on and receiving the streaming GPS data.
This can be verified by opening your mapping software program. In addition, the GPS has a built-in
LED status indicator that shows the following:
LED OFF:
GPS receiver is off (no power).
LED ON
(solid): No fix, searching for GPS signals.
LED FLASHING:
Position fix established and GPS signals are being received.
Why does the GPS not work near buildings and other tall objects?
The GPS uses satellites in the space to find out where it is. Therefore it needs a clear view of the sky.
Tall buildings and other objects that block the receiver’s view to the sky make it infeasible to determine
your location. Sometimes the satellites are not overhead but near the horizon. In these cases the
GPS must have a clear view of the horizon.
Other Comments-
Please allow an adequate amount of time for the GPS receiver’s boot-up (TTF) to complete before
contacting Technical Support.
Driver updates can be found at u-blox ’s web-site:
http://www.u-blox.com/en/evaluation-tools-a-software/u-center/u-center.html
.
8. CONTACT INFORMATION
Headquarters
:
3F., NO.515,Chung Cheng Rd.,Chung Ho City,Taipei County
235,Taiwan(R.O.C)
PAGE 10 OF 14