Unipro UniStop V2, Руководство пользователя

Страница: 12 / 28

12
Operating UniStop
R e f e r e n c e
G u i d e
OPERATING MODES
The stop watch has different modes or screens.
You change between the different modes with
the buttons.
TURN UNISTOP ON
To turn on UniStop you simply press the
MENU button. The display shows the start-up
screen with the logo and more information
about UniStop, for instance software version
and owners’ name.
Startup screen with software version and
serial number.
At the same time UniStop is counting down
to start with the colored backlight. From red,
yellow to green. After the countdown, UniStop
starts in the “Stop watch”.
It is, however, possible to skip this start-up
phase. If you press the
MENU twice instead of
just once, UniStop starts directly in the “Stop
watch”, ready to use. It will skip the startup
screen and thereby reduce the startup time.
You can also jump directly to the “Main menu”
by pressing the
OK button after pressing the
MENU button.
It is possible to change the text at the bottom
line. At default this is set to “www.unipro-
laptimer.com” but you can for example set it
to your own name. The maximum number of
characters is 25. This is done from the Unipro
app.
BACKLIGHT
The backlight can be turned on and off manu-
ally. By default, it is always off. The reason
is that the backlight uses a lot of power. At
50% the power consumption is double and at
100% more than three times as much.
You turn the backlight on and off from the
popup menu. Just press the
MENU button
and select “BACKLIGHT”. Every time UniStop is
turned on, the backlight will be off again, un-
less you set a special option to remember the
backlight setting at power on and off. You do
this by pressing and holding
S2 while turning
UniStop on. This is a toggle function, so you
can switch between remembering backlight
and not by repeating it.
STOP WATCH
The stop watch screen is the most important
screen on UniStop! It is here the timing of the
drivers are done.
Depending on the number of stop watches
running, you will see different layouts of the
screen. If you are only timing one driver, you
will see more information than if you are tim-
ing four drivers!
Stop watch screen ready to start.
When you want to start the stop watch, simply
press
L1 to start the timing of driver one, L2
for start the timing of driver two and so on.
You will see the corresponding stop watch
running in the display. Notice, that if you set
UniStop to use “multistart”, all drivers will start
at the same time. Please see “MULTISTART
SETUP” on page 21.