Unipower Sageon II Bulk, Руководство по эксплуатации продукта, Страница: 7 / 58

General Warning Sageon II Bulk Product Manual
PM990-5201-00, Rev 7 1-1
1. GENERAL WARNING
1. This equipment has been designed to be used only in restricted access areas.
2. This equipment must only be serviced by authorized and qualified service personnel.
3. Operators should not attempt to repair faulty units. There are no operator serviceable parts inside. All fuses are only
replaced as part of a repair procedure in a repair facility by authorized personnel and not as a maintenance procedure on
site.
4. The power Module magazine should be mounted in a rack that satisfies the requirements for electrical enclosures and fire
enclosures according to IEC60950 or equivalent standard. For open rack use, the back of the magazine must be fully
enclosed by its covers and the AC wiring terminations must be protected by either a grounded casing or an enclosure that
provides double insulation.
5. The power shelves must be used with sufficient ventilation. After mounting, the air flow paths into and out of the
rectifiers must be unrestricted. Allow adequate flow for exhaust air out of the rack.
6. Rectifiers are live at all times when the rectifier is plugged into the backplane connector. The input AC disconnection
device is the rectifier backplane connector.
7. When removing modules, especially if the ambient temperature is high and the unit has been operating at maximum load,
avoid skin contact with the metal casing, as it may be too hot to touch. Pull the unit halfway out of the magazine and let
cool for 2-3 minutes before handling.
1.1
PRODUCT SUPPORT
Product support can be obtained using the following addresses and telephone numbers.
Corporate office:
UNIPOWER, LLC
210 N University Dr
Coral Springs, FL 33071
United States
Manufacturing facility:
UNIPOWER, LLC
65 Industrial Park Rd
Dunlap, TN 37327
United States Manufacturing facility:
UNIPOWER Slovakia SRO
ZLATOVSKA 1279
Business Center 22
91105 Trencin, Slovakia
Phone: +1-954-346-2442
Toll Free: 1-800-440-3504
Web site – www.unipowerco.com
When contacting UNIPOWER, please be prepared to provide:
1.
The product model number, spec number, S build number, and serial number - see the equipment nameplate on the front
panel
2. Your company’s name and address
3. Your name and title
4. The reason for the contact
5. If there is a problem with product operation:
•
Is the problem intermittent or continuous?
•
What revision is the firmware?
•
What actions were being performed prior to the appearance of the problem?
•
What actions have been taken since the problem occurred?