Unipower Sageon II Bulk, Руководство по эксплуатации продукта

Страница: 19 / 58

Installation Sageon II Bulk Product Manual
PM990-5201-00, Rev 7 3-8
This cable must be sized accordingly to carry the battery short circuit current for the time required to clear the battery
protection devices.
Note: Ensure the battery circuit breakers are open before connecting the batteries. Connect the switched cable connections
first, followed by the common return cable connections.
3.6
TEMPERATURE SENSORS
The optional sensors for measuring ambient and battery temperature are the same device (Part No. 385-5941-03, -06, -15, -
30). The system auto-detects if the sensor is plugged into one of the positions (4) or (5) shown in Figure 26. If no sensor is
installed, the Controller will show “Not Available” in the menu items for the temperature measurements. Locate the ambient
sensor close to the intake air zone of the Power Module. Locate the battery sensor on a battery block in the middle Module
of the battery bank (likely hot zone).
3.7
AUXILIARY RELAY CONNECTIONS
Figure 3-13 Communication Interface Board (opt) & Multiple Alarm Board
The user configurable auxiliary relays contacts are shown above. The contacts are rated for 1A 250VAC or 1A 32VDC and
have >1kV isolation to the coils.
The pin configuration is: (Pin 1 location in Figure 3.8)
Relay # Pin # Pin function
The relays, being user configurable, can be arranged to
activate for multiple alarm conditions or a single alarm only.
The logic can be inverted for individual relays so that one
becomes a controller failure indicator (use the normally
closed contact as this will also indicate if the relay power
has failed).
1 1 N.O. (normally open)
2 N.C. (normally closed)
3 C (common)
2 4 N.O.
5 N.C.
6 C
3 7 N.O.
8 N.C.
9 C
4 10 N.O.
11 N.C.
12 C
5 13 N.O.
14 N.C.
15 C