Unipower Sageon II Bulk, Руководство по эксплуатации продукта

Страница: 37 / 58

Appendix A – Setting Up Network Interfaces Sageon II Bulk Product Manual
PM990-5201-00, Rev 7
7-2
*** Lantronix Cobox Universal Device Server ***
Serial Number 1297-041 Software Version V03.9 (000211)
Press Enter to go into Setup Mode
Note: If Enter is not pressed within 3 seconds the connection will be terminated .
•
If Enter was pressed within time-out window, a message similar to the sample below will be printed to Telnet window:
*** basic parameters
Hardware: Ethernet Autodetect
IP addr 192.168.000.098, no gateway set
***************** Channel 1 *****************
Baudrate 09600, I/F Mode 4C, Flow 00
Port 10001
Remote IP Adr: --- none ---, Port 00000
Connect Mode: C0 Disconn Mode: 00
Flush Mode: 00
Change Setup : 0 Server configuration
1 Channel 1 configuration
7 Factory defaults
8 Exit without save
9 Save and exit Your choice ?
Type 0 followed by Enter.
The first item in server configuration is local IP address. That has been programmed already, but it is necessary to go through
all bytes. Information in brackets shows current setting, which can be modified by typing new entry followed by Enter key.
Next item after IP address reads:
Set gateway IP address (N)
[or (Y)]
If value is (Y) – just press Enter, if (N) – press ‘Y’ followed by enter. Next item will be:
Gateway IP address (nnn)
Enter assigned gateway address, then press Enter at each item until set up menu is shown again. Terminate Telnet session by
typing 8 or 9.
7.2
PROGRAMMING IP ADDRESSES USING ARP AND TELNET ACCESS
Procedure described below is recommended for advanced users with understanding of operation of networks.
7.2.1 Preparations for local address set up
•
From your network administrator obtain new IP address. Also ask for your network class.
•
Connect PC to the controller’s network interface (directly or via a network).
•
Power-up the controller
7.2.2 Local IP address set up procedure
The following section is excerpted from Lantronix "Embedded Integration Kit" Revision D 06/03/02, Part Number 900-
226.
The unit’s IP address must be configured before a network connection is available. If the unit has no IP address, you
can use Address Resolution Protocol (ARP) method from Windows-based systems to assign a temporary IP address.
If you want to initially configure the unit through the network, follow these steps:
1. On a Windows-based host, create an entry in the host's ARP table using the intended IP address and the hardware
address of the unit, which is found on the product label on the bottom of the unit.
arp -s 191.12.3.77 00-20-4A-xx-xx-xx
Notes: