Unipower Sageon II Bulk, Руководство по эксплуатации продукта

Страница: 38 / 58

Appendix A – Setting Up Network Interfaces Sageon II Bulk Product Manual
PM990-5201-00, Rev 7
7-3
i. The IP address used here is an example and a value within the range of allowable IP addresses in your
network may need to be used. The DOS command ipconfig with display the IP address of the
Windows-
based host machine.
ii. For the ARP command to work on Windows 95, the ARP table on the PC must have at least one IP address
defined other than its own.
2. If you are using Windows 95, type ARP -A at the DOS command prompt to verify that there is at least one entry
in the ARP table. If the local machine is the only entry, ping another IP address on your network to build a new
entry in the ARP table; the IP address must be a host other than the machine on which you are working. Once there
is at least one additional entry in the ARP table, use the following command to ARP an IP address to the unit:
arp -s 192.168.0.97 00-20-4a-xx-xx-xx
3. Open a Telnet connection to port 1. The connection will fail quickly, but the unit will temporarily change its IP
address to the one designated in this step.
telnet 192.168.0.97 1
4. Finally, open a Telnet connection to port 9999, and press Enter within three seconds to go into Setup Mode. If you
wait longer than three seconds, the unit will reboot.
telnet 192.168.0.97 9999
5. Set all required parameters
Note: The IP address you just set is temporary and will revert to the default value when the unit 's power is reset
unless you log into the unit and store the changes permanently. Refer to the chapter on configuration for
instructions on permanently configuring the IP address.

Lantronix, Inc, 2002, all rights reserved, used herein by permission from Lantronix.
7.2.3 Configuring the Unit
The following section is excerpted from Lantronix "Embedded Integration Kit" Revision D 06/03/02, Part Number
900-226.
You must configure the Lantronix Interface so that it can communicate on a network with WinCSU-2 and
communicate with the Sageon II Bulk Controllers unit via the serial port.
The unit’s configuration is stored in nonvolatile memory (NVRAM) and is retained without power. You can change
the configuration at any time. The unit performs a reset after the configuration has been changed and stored.
7.2.3.1 Using a Telnet Connection
To configure the unit over the network, establish a Telnet connection to port 9999.
1. From the Windows Start menu, click
Run and type the following command, where x.x.x.x is the IP address and
9999 is the unit’s fixed network configuration port number.
telnet x.x.x.x 9999 (Example: telnet 192.168.100.123 9999)
Note: Be sure to include a space between the IP address and 9999.
2. Click
OK .
3. The Lantronix Universal Device Server window displays.
*** Lantronix Cobox Universal Device Server ***
Serial Number 1297-041 Software Version V03.9 (000211)
Press Enter to go into Setup Mode
4. To enter the Setup Mode, you must press Enter within 3 seconds.