3
PCM500 SERIES
OPERATING MANUAL
u
Compatible with All UNIPOWER Telecom Rectifiers
u
Easy Wire Connections on Rear
u
Alarm Enable Switches on Back Panel
2.2
Options
u
Centralized Plant Equalize Voltage Adjust
u
Battery Temperature Compensation (with Temp. Probe)
u
Meter Panel (Voltmeter & Ammeter)
3.0
SAFETY WARNINGS
3.1
This Control and Monitor System operates at voltages that could potentially
be hazardous. Furthermore, inadvertant short circuiting of the system battery
and/or rectifier by misconnection or other error could be harmful. This prod-
uct should be handled, tested and installed only by qualified technical per-
sons who are trained in the use of power systems and are well aware of the
hazards involved.
3.2
When operating the PCM500 the chassis ground terminal must be con-
nected to the system frame ground or other proper safety ground for the
protection of personnel.
3.3
All connections to the PCM500 should be carefully checked for errors before
applying power to it.
3.4
This equipment is intended only for installation in a “RESTRICTED ACCESS
LOCATION”.
4.0
WARRANTY
All products of UNIPOWER Telecom, a division of UNIPOWER Corporation, are warranted for
two (2) years from date of shipment against defects in material and workmanship. This warranty
does not extend to products which have been opened, altered or repaired by persons other than
persons authorized by the manufacturer or to products which become defective due to acts of
God, negligence or the failure of customer to fully follow instructions with respect to installation,
application or maintenance. This warranty is extended directly by the manufacturer to the buyer
and is the sole warranty applicable. EXCEPT FOR THE FOREGOING EXPRESS WARRANTY,
THE MANUFACTURER MAKES NO WARRANTY, EXPRESS OR IMPLIED, INCLUDING, BUT
NOT LIMITED TO, THE WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICU-
LAR PURPOSE. As the sole and exclusive remedy under this warranty, the manufacturer, at its
option, may repair or replace the non-conforming product or issue credit, provided the
manufacturer’s inspection establishes the existence of a defect. To exercise this remedy, the
buyer must contact the manufacturer’s Customer Service Department to obtain a Return Material
Authorization number and shipping instructions. Products returned without prior authorization
will be returned to buyer. All products returned for repair must be shipped freight prepaid to
UNIPOWER. If the buyer fails to fully comply with the foregoing, the buyer agrees that no other
remedy (including, but not limited to, incidental or consequential damages for lost profits, lost
sales, injury to person or property or any other incidental or consequential losses) shall be
available to the buyer.
