16 pc. Mini Die Grinder Kit
2
•
Ensure that your hair does not get caught in the rotating tool. Wear a hair net for your safety.
•
Wear close-fitting clothing. Wide, loose clothing can get caught in the rotating tool and can lead to injuries.
•
Keep your workplace clean and in good order. Untidiness in the workplace increases the risk of accidents.
•
New grinding tools must be run-in by running it idle for half a minute.
•
Never slow down the grinder by pressing on it. At low rotational speeds, the lateral pressure can damage the
grinder.
General Instructions
•
The recommended working pressure level is 6.2 bar.
ATTENTION
! A level of working pressure that is too low leads to reduced performance, a level of working
pressure that is too high shortens the service life.
•
Wipe the tool with a dry cloth. Never clean it with water or solvents. Solvents damage the seals. Water leads
to corrosion.
•
Always store the axial grinder in a dry and clean place.
•
In case of improper use and lack of maintenance, the legal warranty is void.
Initial Start-Up
1. Fill three to four drops of pneumatic oil into the compressed air supply.
2. Screw the couplings and plugs that are included with the delivery into the compressed air supply and seal it
with Teflon tape.
3. Select the grips D that are suitable for the grinder F. The shaft of grinder F must fit into the grips D.
4. First, turn the clamping nut E loosely onto the thread of the grips bearing.
5. Slide the grinder Fin the grips D to a maximum distance of 1 cm and tighten the clamping nut with a spanner.
Hold the spindle in place with a spanner. The clamping nut must be tightened to the extent that the grinder is
held in place.
Required Air Quality/Air Supply
Air quality should be cleaned; air supply should be coated in oil via a maintenance unit with filter pressure
reducers and inline oiler.
Setting Values for Operation
Change the operating pressure (flow pressure) on the pressure reducer to 6.2 bar.
