Administration
A31003-S2030-M100-11-76A9, 01/2015
292
OpenStage SIP V3R3 for OpenScape Voice, Administration Manual
administration.fm
Diagnostics
3.26.11
Bluetooth Advanced Traces
For OpenStage 60/80 phones, low level Bluetooth traces can be controlled and viewed via web
interface, in addition to the tracing facilities available in previous firmware versions (see Section
3.26.9, “Fault Trace Configuration”). Internally, the phone uses the hcdump utility for creating
the traces. It is also possible to run the trace from the shell via SSH (for information about the
SSH access, please refer to Section 3.24, “SSH – Secure Shell Access”).
If
Automatic clear before start
is enabled, the log file will be emptied before the
Start
button
is pressed, so that the log file will only containd newly created entries. By default, this param-
eter is enabled.
The
File size (Max 6290000 bytes)
parameter determines the maximum size of the log file. If
this value is exceeded, no more data will be written to the file. The default value is 265536.
If
Extended dump
is enabled, all hexadecimal and ASCII data is displayed for each packet. If
disabled, only the packet type is displayed. By default, this parameter is enabled.
If
Verbose decoding
is enabled, the packets are decoded in a more verbose way. By default,
this parameter is enabled.
With the
Start
/
Stop
button, tracing is started or halted. The label depends on whether tracing
is active or not.
On clicking the
Download trace file
link, the trace file is displayed.
With
Submit
, the changes on the parameters described above are sent to the phone.
With
Reset
, parameter changes that have been made in the form, but not yet sent to the phone,
are cancelled.
Administration via WBM
File size (Max 6290000 bytes)
Extended dump
Verbose decoding
Bluetooth Advanced Traces
Submit
Reset
256000
Tracing is stopped
Download trace file
Automatic clear before start
;
;
;
Start